Dennis Baldwin - Channel
-
Pixhawk TailSitter/Multirotor Transmitter PID Gain Tuning Overview
It was too windy to tune the Pixhawk Sweepwings Flinch tailsitter today so I decided to walk thro... -
QAV400 Tight Squeeze - Keep Your Wires Securely Mounted
I just wanted to share my experience from a recent FPV flight. It was scary to see the signal go ... -
New Version of DJI F450 Leg Extensions with Bolt-on Design
Many thanks to Gavin for improving upon my original design. You can check out his YouTube page he... -
DJI F450 3D Printed Top Plate w/ MakerBot Replicator 2
First off, please sign up at garagepilots.com where there will be more multirotor 3D printing mad... -
NAZA Lite and TBS Discovery with Turnigy 9XR 3 Flight Modes - GPS Attitude, Manual, & Failsafe
To setup your Turnigy 9XR for 3 flight modes please watch this: This was a quick backyard test ... -
Basic FPV Monitor Signal Test w/ 7" Digital Prism LCD Monitor and GoPro Hero
Here is the link to the battery-powered Digital Prism monitor for just $50 on Amazon: Just a qu... -
Using GDAL Tools to Convert Drone Imagery and Orthomosaics to Google Map Tiles
This video walks through converting orthomosaics in geotiff format to Google map tiles. You can d... -
Turnigy 9XR 3 Position Switch for Different Flight Modes w/ NAZA Lite and TBS Discovery Quadcopter
This is a TBS Discovery & NAZA Lite build using the Turnigy 9XR. I'm doing this configuration for... -
Getting DronePan Working With 3DR Solo Using DroneKit - First Impressions
I finally pulled the trigger on a 3DR Solo. Many have asked about getting DronePan working with t... -
SweepWings Flinch & ArduPilot Tailsitter Backyard Maiden
Although there is lots of room for improvement this maiden went much better than expected. I thou... -
Extending 3D Printed Motor Mounts for ArduPilot/Pixhawk Tailsitter
I ran into a problem with my Pixhawk dual tailsitter and SweepWings Flinch. My motor mounts weren... -
Pixhawk 2 Cube and SweepWings Flinch Tailsitter w/ APM:Plane Firmware
I wanted to share an update on my tailsitter progress so far. I've installed and configured APM:P...
