DragonFly32 Flight Controller Minimalistic Pin Setup

How to setup your Dragon32 Flight Controller with minimal pins for a nice clean build.
This method takes advantage of CPPM so you only have one wire from the receiver to the flight controller and only using signal cables from the ESC's to the FC with exception of one for power to the FC.
NOTE: When I discuss the vbat and beeper pins I just wanted to clarify that the beeper pins do not follow the standard of ground pin on the outside and positive pin on the inside. The beeper pins are reversed where positive is on the outside and negative is on the inside pin. This is the same on all flip32 style boards and not specific to the MRM DragonFly32 board. I was only trying to bring your attention to the fact that one of them was reversed.
Thank You for MultiRotorMania.com for sponsoring us and making these videos possible. Please visit their site and take a look at all the goodies they sell.
You can find this flight controller for purchase on their website at -
Please Like, Share, And Subscribe to our videos and help us spread the word.
Follow us:
Website:
FaceBook:
Twitter: