WLtoys Q393-A FPV altitude hold quadcopter review and flight

Buy it at Gearbest:
Gearbest Summer Sale:
The WLToys Q393-A is a new FPV quadcopter with altitude hold, remote adjustable camera, telemetry in the transmitter, and up to 13 minutes of flight time.
Also available are the following:
WLToys Q393 (No Camera):
WLToys Q393-E (WiFi FPV):
Flight performance wise it is not too bad at all, relatively speedy in the high speed mode for its size. Performs decent in the wind but you definitely use the high speed mode in winds over 10MPH.
Flight times are around 10-12 minutes and you have at least 1 minute after the LVC starts to return and land safely. Speaking of the LVC when it actually goes into that mode the quadcopter flashes AND the transmitter beeps so you don't have to watch the quadcopter to know.
Video quality is not too bad but I feel it could be a little bit sharper, FOV is very high, and there is some video wobble. I think a lot of the video wobble is caused by unbalanced propellers because the wobble was a lot less before I nicked a tree.
The remote adjustment works as advertised and while the actual range of adjustment is short the high FOV makes up for it.
The transmitter is very nice featuring an LCD screen that displays flight mode, speed mode, actual quadcopter speed, altitude (in meters), and flight time in a seconds format.
FPV screen works good but it could be a little brighter as it can be hard to see in the sun. FPV latency is very low and the signal quality is very good.
Overall a pretty decent quadcopter and I enjoyed flying it.
Thanks to gearbest for sending me this to review, the above link is an affiliate link and I get a small commission if you purchase something at no cost to you.