Super Mario Flying RC Go-cart Construction

In this video, I show you how to build the Super Mario Flying RC Go-cart. The original design is called the SkyCart. It was designed by www.rcgroups.com users leadfeather and motorhead.
For a full transcript and the list of items used see
Watch the flight video here:
Links to supplies needed. BTW, if you like my videos please use these videos when you make a purchase and I will get a small credit. Thanks.
1. Transmitter and receiver of your choice.
2. hexTronik 24gram Brushless 1300kv Motor:
3. Stick motor mount:
4. 10 Amp ESC:
5. 8x6 Propeller:
6. Prop saver :
7. 3-cell LiPo battery, 800mah (could go as low as 300mah and try a 2-cell instead):
8. Two control rods for elevons (I used 3mm carbon fiber tubes with 2mm threaded rods inserted with CA, but you could use something else)
9. Rudder control rod: used one Hobby Zone Super Cub control rod, cut to 3.5" inches.
10. Three 9 gram HXT 900 servos:
11. 3.5mm bullet connectors for ESC and motor (3 male, 3 female):
12. Power connector for ESC to match battery (e.g. JST female connector):
13. For main wing, sides and vertical stabilizer, one 24x36 9mm 1.3# EPP foam sheet:
Could also get away with Dollartree foam board, but it won't be as flexible and crash-resistant as EPP.
14. 3mm Carbon fiber tube for front support (15"), rear support (15") and rear axles(2 x 6"):
15. Two 6" long 1.5mm diameter piano wire for front axles. Wire needs to fit inside CF tube.
16. Scotch Extreme Tape for hinges:
17. Also for hinges, Welders glue or Beacon Foam-Tac glue:
18. 3M Spray adhesive to glue character printout onto vertical stabilizer: (also used for helping hinge tape stick to EPP)
19. Use hot glue for gluing most of the pieces together, except the hinges.
20. For motor brace, two 4" 3mm carbon fiber tubes or bamboo skewers.
21. For making wheels, one 1" foam board from Home Depot, Lowes or Hardware store. You could also use EPP method described in the RCGroups thread.
22. Eight plastic gift cards for making wheel hubs and control horns.
23. For front axle side supports, two 1" x 1-5/8" plastic gift cards or plywood pieces
24. For wheel collars, fuel tubing or hot glue.
25. Velcro to keep ESC, battery and receiver in place.
26. Spray paint, if you want to paint it.