Raw FPV Racing Fun
This course was so much fun, the added lift at the end into the blind Airgate was a great challenge but Damped light came in very useful to get that instant drop after the ascending ramp.
Thank you to the guys at Hoverspeed RC for providing the excellent course and venue to have some fun FPV Racing, check out their website:
This flight is using the Gens Ace Tattu 1300mAh 45C (75C Burst) 11.1v lipo, these packs have performed excellent in the longer races, lasting the duration of the laps with no noticeable voltage sag under heavy load, the pack was just above ambient temperature after I recovered the quad, check them out here:
Setup:
Emax 250Pro Carbon fibre Frame
Cobra 2208 2000Kv motors
Gemfan 5x45 Bullnose props
RCTimer SN30 ESC with BlHeli 14.0.2 Oneshot/Damped Light
Sparky FC with Cleanflight 1.9.0 stock PIDs
Gens Ace Tattu 1300mAh 45C-75C 3s Lipo
All footage was taken using a Runcam HD 2.0 Lens Camera, check out their website to get your hands on one:
/
This quad is normally run on a 4s setup but I wanted to have a fairer race with other pilots also running 3s. The rattle sound is made by a loose 3D printed Camera mount.
Thank you to Mark, Mike and Adrian for an excellent time racing on this course. Check out Marks video from the day:
Thank you to the guys at Hoverspeed RC for providing the excellent course and venue to have some fun FPV Racing, check out their website:
This flight is using the Gens Ace Tattu 1300mAh 45C (75C Burst) 11.1v lipo, these packs have performed excellent in the longer races, lasting the duration of the laps with no noticeable voltage sag under heavy load, the pack was just above ambient temperature after I recovered the quad, check them out here:
Setup:
Emax 250Pro Carbon fibre Frame
Cobra 2208 2000Kv motors
Gemfan 5x45 Bullnose props
RCTimer SN30 ESC with BlHeli 14.0.2 Oneshot/Damped Light
Sparky FC with Cleanflight 1.9.0 stock PIDs
Gens Ace Tattu 1300mAh 45C-75C 3s Lipo
All footage was taken using a Runcam HD 2.0 Lens Camera, check out their website to get your hands on one:
/
This quad is normally run on a 4s setup but I wanted to have a fairer race with other pilots also running 3s. The rattle sound is made by a loose 3D printed Camera mount.
Thank you to Mark, Mike and Adrian for an excellent time racing on this course. Check out Marks video from the day:
Fpvracer.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.