First look at F4 v5pro AIO!

Thanks to HGLRC for this brilliant board! Betaflight. Betaflight OSD, 200A current sensor, 6s capable PDB 2-5V 3A BEC, switchable 40ch 25/200/600mw vtx, f405 chip. Mpu6000 over spi. Basically all you need is this. A frame. A cmos or ccd camera. A 5.8ghz antenna. Radio rx. Motors and esc's and thats it! Clutter free full featured builds! manual found here.
Flash with omnibus f4 target v3.11 and above.
Specs are :
Processor: STM32F405RGT6
IMU: MPU6000
Firmware: BetaFlight 3.1
Power supply: 2 - 6S LiPo
Max. current support: 200A
BEC: 5V 3A, unsure if buck type...
Mounting hole spacing: 30.5 x 30.5mm
VTX frequency: 5.8GHz
Channels: 40 including RaceBand, Band E
Output power: 0 / 25mW / 200mW / 600mW
Antenna adapter: with RP-SMA female connector
to enter the f4v5pro giveaway. simply like, subscribe, and comment f4v5pro to be considered as an entrant. the winner will be contacted via youtube to ask for personal email and address to send the f4v5pro board too.. (my one requirement is that you do a half decent video talking about your experiences and pro's and con's. submit the video to me to add to an edit. or throw it up yourself. its all good.) just gotta get more opinions on this board. before i finalise my own. GOOD LUCK!
the new board has been sent as of yesterday, so it will be a couple of weeks before it arrives and i do the draw! NOTE im not asking you to share, so that each entrant has a better chance of winning. i want active people in the hobby to win as i know the board will be thoroughly tested.