FPV Racer Power Connector, CC3D & ESCs Soldering

This is the continuation of my FPV racer build, here I cover adding the power cable, tips on soldering it to the power distribution board and soldering the ESC (electronic speed controllers) to the PDB. I also install and wire my CC3D Board from OpenPilot.
Motors: EMAX MT1806 2280KV Motor & Emax Simonk ESC for my FPV Racer
These Motors are perfect for a 250 size quadcopter FPV build for fpv racing, park racing and overall great performance for 230 to 250 sized drone racers, they come with 3 sets of screws, in different sizes. The Emax Simonk Series ESC are based on Simon K firmware perfect size and weight got FPV raccers like QAV250 Quadcopters and other styles of mini fpv racers.
Motor Specs.
Brand Name: Emax
Item Name: MT1806 motor
KV: 2280
No. of cell: 2 - 3S
Framework: 12N14P
Shaft: 2mm
Diameter: 26.7mm
Length: 23mm
Weight: 18G
Propeller: 5 - 6 inch
ESC Specs.
Brand Name: Emax
Item Name: Simonk Series ESC
Current: 12A
Input: 2-3S LiPo
Dimension: 22*17*7
Weight: 8g
BEC output: 1A/5V
Programmable: Yes
Based on Simon K firmware, further optimized to perfect drive performance. Low-voltage protection, over-heat protection and self-check functions. Separate power supply for MCU and BEC, enhancing the ESC’s ability of eliminating magnetic interference. Parameters of the ESC can be set via program card or transmitter. Throttle range can be set to be compatible with different receivers. Equipped with built-in BEC. Max speed: 210,000 rpm for 2-pole, 70,000 rpm for 6-pole, 35,000 rpm for 12-pole.