DampenedLight Twitching Part 2 - #SolvedForReals
In the last video we did some diagnosis of the Yaw twitching issue on my 210mm Quadcopter. While we were able to solve the twitching, we left other issues outstanding. In this episode we revisit the solution and wind up with what appears to be a real solution to the problem.
After a recap of the prior episode, we install rubber o-rings on all of the motor mounts and then proceed to try it out with a series of hover test. We cap off the episode with a flying session in the park.
My Setup:
Frame: QAV210 Clone
Motors: Emax 2205-2600KV
ESCs: Littlebee BLHeli 20A Multishot
Props: KingKong 5040 / Gemfan 5040 Triblade
FC: SPRacing F3 Evo
Board Camera: Runcam Swift 2.1mm
Video Camera: GoPro Session 5
VTX: ReadyToSky 600mW
Battery: Tattu (1550 3S 75C / 1300 4S 75C)
Receiver: Frsky XSR
Transmitter: Frsky Taranis X9D Plus
Firmware: Betaflight 3.0.1
After a recap of the prior episode, we install rubber o-rings on all of the motor mounts and then proceed to try it out with a series of hover test. We cap off the episode with a flying session in the park.
My Setup:
Frame: QAV210 Clone
Motors: Emax 2205-2600KV
ESCs: Littlebee BLHeli 20A Multishot
Props: KingKong 5040 / Gemfan 5040 Triblade
FC: SPRacing F3 Evo
Board Camera: Runcam Swift 2.1mm
Video Camera: GoPro Session 5
VTX: ReadyToSky 600mW
Battery: Tattu (1550 3S 75C / 1300 4S 75C)
Receiver: Frsky XSR
Transmitter: Frsky Taranis X9D Plus
Firmware: Betaflight 3.0.1
Fpvracer.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.