Setting up Your BetaFPV Beta 65s Lite with the Taranis QX7

Hello everyone welcome back.
In today's video I will be showing you how to bind your new BetaFPV Beta 65s Lite running Bayang Protocol to your Taranis using the MTX-9D Module. This was a really easy setup and I also included the needed stick gestures to change your PIDS and Flight modes.
Here are the instructions to set up your profile.
Binding Procedure
1. Create a model in OpenTX using external module in PPM mode, 12 channels and AETR
sequence order. 2. Turn off Taranis. 3. Power up quad. 4. While holding the appropriate stick pattern listed below, power up Taranis.
To Bind you will need to have you left stick in the center and down position. On your Right stick you will have it held to Elevator up + Aileron right when you power on your transmitter. THis will bind your Beta 65s lite to your Taranis. You will notice that your rapidly blinking lights have now changed to solid. You are now ready to fly.
This little guy also rocks silverware out of the box.
Pick up a BetaFPV Beta65s Lite today
Pick up a MTX-X9D Module
Dont forget to check out C Ray Prints.
What I fly and what I use
BNF Beta85
BNF Beta75s
BNF BetaFPV Beta 65
BetaFPV Beta 65 Frame Kit
BetaFPV Flight Controller with Frsky Receiver & BetaFlight OSD
BetaFPV Flight Controller with DSMX Receiver & BetaFlight OSD
BetaFPV Z01 Camera
BetaFPV 230mah LiHV Batteries
BetaFPV Replacement Canopies
BNF Beta 75s
BNF Beta 75
Beta 65s
FPV Goggles I use
Soldering Iron I use
I film all my videos with the Samsung Note 5
Thank you for watching!
Fly Safe & Fly Often