Trainer 90 1s Brushless FPV DIY Kit
In this video, I build the Happymodel Trainer 90 1s Brushless FPV DIY Kit from start to finish... well, almost. Sadly one of the motors broke -- after all of that micro soldering! I'll show you what I did so you can learn from me and avoid the same fate. My Trainer 90 will be up and running in a later video after I get a new motor, but that will be a while.
─── Build Timeline ───
0:33 - fusion x3 flight controller power lead soldering
1:37 - frsky sbus d8 receiver soldering
2:16 - fpv all-in-one camera soldering
3:12 - buzzer soldering
3:39 - carbon fiber frame mounting fc
3:54 - 3d printed camera mount
4:55 - 15000kv motor mounting & soldering
6:00 - what went wrong
─── Purchase Links ───
─── Build Timeline ───
0:33 - fusion x3 flight controller power lead soldering
1:37 - frsky sbus d8 receiver soldering
2:16 - fpv all-in-one camera soldering
3:12 - buzzer soldering
3:39 - carbon fiber frame mounting fc
3:54 - 3d printed camera mount
4:55 - 15000kv motor mounting & soldering
6:00 - what went wrong
─── Purchase Links ───
Fpvracer.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.