Removed Betaflight Filters - SunnySky 2305 motors

Soft mount FC and remove filters make a big difference in flight characteristics so responsive!
/
Steps:
set d_lowpass_type = PT1 (in the CLI) should always be done first and I think possible on every setup.
Hover your quad for a minute see if the motors get hot... if hot you should stop and revert back, If it is still fine than:
Remove notch 1 (set Freq = 0 in the config GUI or CLI to disable Notch filter)
Check motors temperature again after a minute of flying.. if still fine remove notch 2
Now if your setup is still clean you could even remove dterm notch.
That will give you the best results. Sharpest response, easiest tuning and literally no prop wash on good setups.
Gear:
Sunnysky R2305 Motors: /
Betaflight F3
Eagle FPV camera
DAL Cyclone 5045
Speed Addict 220 Frame