How to fit any VRx module into your Fatshark goggles (feat. Attitude V3) - EASY FIX

If you own a set of older Fatshark goggles - especially one of the Attitude series - you may have tackled this issue already.
I like my Attitude V3s a lot. I have modded them to my liking, have added a wide comfortable head strap, a DVR with all the wiring internally and have been enjoying them a lot, using various VRx modules.
Most of the aftermarket modules cannot fit into the module bay of the Attitudes though. The tabs that are around the edge of the module bay don't allow for the rear PCB of the modules to be inserted and the pins cannot reach the connector of the goggles. Also the inside part of the module bay may not be tall enough for some modules.
Yes, you can add an extender to the pins and raise them enough to fit the module but it sticks far outside the goggles and is not sturdy enough to support antennas and withstand daily use.
Trimming the tabs of the module bay and grinding the edges of the module's PCB does the trick just fine and the fit is perfect after this simple fix.
This is EASY FIX: How to fit "any" VRx module into your Fatshark goggles (feat. Attitude V3) - Let's go!
____________________
*If you like my content and want to support the channel, you can use the affiliate links below. I get a small kickback from the store if you decide to buy something and it costs nothing extra to you.
Thank you in advance!
RX5808 Pro module: (Banggood)
or: (Ebay)
RX5808 Pro Plus module: (Banggood)
or: (Ebay)
Pro58 module: (Banggood)
or: (Ebay)
For the Achilles firmware on the RX5808 modules, you can check my video here:
-------------------------------
This video features the song "First Day" by Huma-Huma, available under a Creative Commons License
Song link:
CC-by license: /
-------------------------------
#FatsharkMods
#muteFPV
#FPVgoggles