Emax Hawk5 "Buttery" 8K/8K Betaflight 3.4 - Tune Below

I've moved back to Betaflight from Butterflight and have managed to get the same smoothness, but a more dynamic tune using the new features, particularly two stage filtering, throttle boost, iterm relax and RC filtering. It's really smooth and yet responsive when I need it.
For the PIDs, I just cranked the I term as I usually do and left the defaults for P and D... Will likely increase P to get a little more authority, but it's impressive for close to stock on the PIDS. I did however spend a lot of time on the filtering and getting the new features setup right for smooth flight that's good for a cinematic feel, but can still snap fast if you need it. I'm flying a little slower in this flight then usual, really wanted to see how smooth the tune was.
Props: Cyclone 5040
Camera: GoPro Session4 @ 30fps (no ND to smooth, it's my tuning cam)
Receiver: Crossfire Nano w/ immortal-T
Battery: Infinity Graphene 4s 1300mah
# Betaflight / OMNIBUSF4 (OBF4) 3.4.0 Jul 8 2018 / 04:23:56
# feature
feature AIRMODE
# master
set gyro_lowpass_hz = 160
set gyro_lowpass2_hz = 320
set mag_hardware = NONE
set baro_hardware = NONE
set rc_interp_ch = RPYT
set rc_smoothing_type = FILTER
set motor_pwm_protocol = DSHOT600
set vbat_max_cell_voltage = 44
set vbat_min_cell_voltage = 32
set vbat_warning_cell_voltage = 33
set current_meter = NONE
set pid_process_denom = 1
# profile
profile 0
set dterm_lowpass2_hz = 250
set dterm_notch_cutoff = 0
set vbat_pid_gain = ON
set setpoint_relax_ratio = 50
set dterm_setpoint_weight = 80
set smart_feedforward = ON
set iterm_relax = RP
set iterm_relax_type = SETPOINT
set iterm_relax_cutoff = 10
set throttle_boost = 8
set i_pitch = 75
set i_roll = 70
set i_yaw = 60
# rateprofile
rateprofile 0
set roll_rc_rate = 80
set pitch_rc_rate = 80
set yaw_rc_rate = 80
set roll_srate = 85
set pitch_srate = 85
set yaw_srate = 85
set tpa_rate = 20
set tpa_breakpoint = 1050
set throttle_limit_type = SCALE
set throttle_limit_percent = 95