3D Printing a Garden Sprinkler
Making a garden sprinkler on a 3D printer.
Settings used to make the parts shown in the video:
Software: Slic3r 0.9.7
3D Printer: Trinity Labs Aluminatus
Material: 3mm ABS
Layer Height: .3mm
Number of Perimeters: 3
Infill: 25% rectilinear
Printing time: Approximately 2 hours.
Links and Sources:
E-Z Sprinkler by ICEPICKTONY
If you are interested in 3D printing, please click the like button and then subscribe to this channel for a series of demonstrations and how-to videos. If you have a question or comment, you can post in the comments below.
Visit www.busybotz.com for 3D printer printed parts, and custom 3D printing service.
Thanks for watching!
Settings used to make the parts shown in the video:
Software: Slic3r 0.9.7
3D Printer: Trinity Labs Aluminatus
Material: 3mm ABS
Layer Height: .3mm
Number of Perimeters: 3
Infill: 25% rectilinear
Printing time: Approximately 2 hours.
Links and Sources:
E-Z Sprinkler by ICEPICKTONY
If you are interested in 3D printing, please click the like button and then subscribe to this channel for a series of demonstrations and how-to videos. If you have a question or comment, you can post in the comments below.
Visit www.busybotz.com for 3D printer printed parts, and custom 3D printing service.
Thanks for watching!
Fpvracer.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.